产品特点

1、采用IGBT 逆变技术，保证焊接规范在电网电压和电弧长度变化时的高度稳定。

2、效率和功率因数高，因而有显著的节电效果和较高的电网利用率。

3、配合控制箱可预置焊接电流，焊接电压。

4、配合控制箱可储存 12 组焊接参数。

5、分别适合细丝和粗丝埋弧焊。

6、485 通信模式，可减少控制线损坏故障。

7、控制箱和主机采用光电隔离，可避免控制线损坏烧毁主板。

8、风机焊接时启动，停焊 10 分钟后停转，可降噪，省电，提高风机寿命。

9、由于采用交流方波输出，电弧稳定，焊缝成形美观，不易产生焊接缺陷。

10、电流调节范围宽。

Product Features

1. Adopting IGBT inverter technology to ensure high stability of welding specifications under changes in grid voltage and arc length.

2. High efficiency and power factor result in significant energy-saving effects and high grid utilization.

3. Cooperate with the control box to preset welding current and welding voltage.

4. Cooperate with the control box to store 12 sets of welding parameters.

5. Suitable for both fine and coarse wire submerged arc welding.

6. 485 communication mode can reduce control line damage and faults.

7. The control box and the host adopt photoelectric isolation, which can avoid damage to the control line and burning of the motherboard.

8. Start the fan during welding, stop welding for 10 minutes and then stop running, which can reduce noise, save electricity, and improve the lifespan of the fan.

9. Due to the use of AC square wave output, the arc is stable, the weld seam is aesthetically pleasing, and welding defects are less likely to occur.

10. Wide range of current regulation.